Piero Bosio Social Web Site Personale

After lunch, I finished correcting squareness, checking if I had to chisel out some bits here and there or if I would be able to get everything right by tightening only. Thankfully, no more carving was required, at least not yet ! Then I grabbed some birch 8mm plywood board and cut them to size on the table saw. I had to change the blade, so I took a picture of the setting.After the boards where cut, I realized my machined grooves were barely too small everywhere. So I carefully took some thickness off the sides of each board with a planer. It's stressfull to do it just enough so it's a tight fit without making it too visible, but I'm very pleased to be good at sharpening my tools: it was a breeze on those birch plywood. It did took more time than I would have liked.And with that I could assemble the whole table body ! And that's where I'm at now. That's the end day 5, which was today, I'll add to this thread when I have more progress to show !Feel free to ask questions about anything ! I'd be pleased to answer and talk.#woodworking