Skip to content

Piero Bosio Social Web Site Personale Logo Fediverso

Social Forum federato con il resto del mondo. Non contano le istanze, contano le persone
  1. Home
  2. Categories
  3. Uncategorized
  4. Monday silliness 🐡🦈🦑

Monday silliness 🐡🦈🦑

Uncategorized
16 12 2
Log in to reply

Feed RSS
Monday silliness 🐡🦈🦑

Gli ultimi otto messaggi ricevuti dalla Federazione
@pierobosio@soc.bosio.info
Post suggeriti
  • anarchiversitario@poliversity.itundefined

    Il comparto bellico si muove, i movimenti contro il riarmo si mobilitano.

    Uncategorized
    1
    0 Votes
    1 Posts
    3 Views
    anarchiversitario@poliversity.itundefined
    Il comparto bellico si muove, i movimenti contro il riarmo si mobilitano. qual è il ruolo dell’italia nei conflitti?@anarchia Logistica di guerra. I movimenti italiani contro il riarmo sono tornati a mobilitarsi contro alla presenza sempre più massiccia di armamenti, munizioni e mezzi militari sul territorio. Da Pisa a
  • livelakehuron@mastodon.socialundefined

    Current* conditions near St. Ignace, MI:

    Uncategorized
    1
    1
    0 Votes
    1 Posts
    2 Views
    livelakehuron@mastodon.socialundefined
    Current* conditions near St. Ignace, MI:
  • cybersecurity@poliverso.orgundefined

    Recycled Plastic Compression Molding With 3D-Printed Molds

    Uncategorized
    1
    3
    0 Votes
    1 Posts
    2 Views
    cybersecurity@poliverso.orgundefined
    Recycled Plastic Compression Molding With 3D-Printed MoldsRecycling plastic at home using 3D printed molds is relatively accessible these days, but if you do not wish to invest a lot of money into specialized equipment, what’s the most minimal setup that you can get away with? In a recent [future things] video DIY plastic recycling is explored using only equipment that the average home is likely to have around.Lest anyone complain, you should always wear PPE such as gloves and a suitable respirator whenever you’re dealing with hot plastic in this manner, just to avoid a trip to the emergency room. Once taken care of that issue, there are a few ways of doing molding, with compression molding being one of the most straightforward types.With compression molding you got two halves of a mold, of which one compresses the material inside the other half. This means that you do not require any complex devices like with injection molding, just a toaster oven or equivalent to melt the plastic, which is LDPE in this example. The scrap plastic is placed in a silicone cup before it’s heated so that it doesn’t stick to the container.The wad of goopy plastic is then put inside the bottom part of the mold before the top part is put in place and squeezed by hand until molten plastic comes out of the overflow opening(s). After letting it fully cool down, the mold is opened and the part released. Although the demonstrated process can be improved upon, it seems to work well enough if you are aware of the limitations. In terms of costs and parts required it’s definitely hard to come up with a cheaper way to do plastic molding.youtube.com/embed/CWjjZHdZ4WQ?…hackaday.com/2026/03/16/recycl…
  • aeva@mastodon.gamedev.placeundefined

    i was just thinking back to when i was an art student.

    Uncategorized
    16
    0 Votes
    16 Posts
    72 Views
    pekkavaa@mastodon.gamedev.placeundefined
    @aeva Ah you took that course too