Brutalist architecture would be easier to like if the ceilings weren’t so forking low.
Uncategorized
5
Posts
3
Posters
19
Views
-
Brutalist architecture would be easier to like if the ceilings weren’t so forking low. I don’t know if that was because of the “affordable” requirement, but I feel a lot of these buildings follow standards from Neufert’s Hobbit edition. #architecture #rant
-
Brutalist architecture would be easier to like if the ceilings weren’t so forking low. I don’t know if that was because of the “affordable” requirement, but I feel a lot of these buildings follow standards from Neufert’s Hobbit edition. #architecture #rant
-
@letterror but in fact the idea that Hobbits' holes had a low ceiling is NOT in Tolkien's books it is ONLY in the movies by PJ (These are very bad adaptations, full of misconceptions. They are films that I deeply loathe.)
Tolkien designed Bilbo's entrance hall with a very high ceiling. -
@letterror but in fact the idea that Hobbits' holes had a low ceiling is NOT in Tolkien's books it is ONLY in the movies by PJ (These are very bad adaptations, full of misconceptions. They are films that I deeply loathe.)
Tolkien designed Bilbo's entrance hall with a very high ceiling.@e_kloczko The beginning of the Hobbit more or less describes a London underground station. Except for the trains, which might have been an exciting addition.
-
@e_kloczko The beginning of the Hobbit more or less describes a London underground station. Except for the trains, which might have been an exciting addition.
@letterror In a hole in the ground there lived a hobbit. Not a nasty, dirty, wet hole, filled with the ends of worms and an oozy smell, nor yet a dry, bare, sandy hole with nothing in it to sit down on or to eat: it was a hobbit-hole, and that means the kind of smart, walkable, mixed-use urbanism that is illegal to build in Mordor, Harad, or Rhûn.
-
undefined oblomov@sociale.network shared this topic on
Gli ultimi otto messaggi ricevuti dalla Federazione
-
@aeva lol yeah the set designers definitely copied Trek’s homework.
-
*grits teeth* full support to comrade GNOME
https://blogs.gnome.org/jrahmatzadeh/2025/12/06/ai-and-gnome-shell-extensions/
-
@brouhaha Next time someone asks, "What is Mastodon?" I'm showing them this.
-
@globalistIT ma invece nei confronti delle occupazioni abusive di stabili e delle manifestazioni e saluti nazisti di "💩paund&co"😠come si pongono?,ovviamente la domanda è retorica🤐
-
@_elena still no simple FTP server that doesn't require 287302723 different config files with 0xDEADBEEF command line options.
Honestly if a ftp server is more complicated than `ftpserver $HOME --write --read` then it is a failed one.
-
-
Plug Into USB, Read Hostname and IP Address
Ever wanted to just plug something in and conveniently read the hostname and IP addresses of a headless board like a Raspberry Pi? Chances are, a free USB port is more accessible than digging up a monitor and keyboard, and that’s where [C4KEW4LK]’s rpi_usb_ip_display comes in. Plug it into a free USB port, and a few moments later, read the built-in display. Handy!
The device is an RP2350 board and a 1.47″ Waveshare LCD, with a simple 3D-printed enclosure. It displays hostname, WiFi interface, Ethernet interface, and whatever others it can identify. There isn’t even a button to push; just plug it in and let it run.
Here’s how it works: once plugged in, the board identifies itself as a USB keyboard and a USB serial port. Then it launches a terminal with Ctrl-Alt-T, and from there it types and runs commands to do the following:
Find the serial port that the RP2350 board just created.Get the parsed outputs of hostname, ip -o -4 addr show dev wlan0, ip -o -4 addr show dev eth0, and ip -o -4 addr show to gather up data on active interfaces.Send that information out the serial port to the RP2350 board.Display the information on the LCD.Update periodically.The only catch is that the host system must be able to respond to launching a new terminal with Ctrl-Alt-T, which typically means the host must have someone logged in.
It’s a pretty nifty little tool, and its operation might remind you, in concept, of how BadUSB attacks happen: a piece of hardware, once plugged into a host, identifies itself to the host as something other than what it appears to be. Then it proceeds to input and execute actions. But in this case, it’s not at all malicious, just convenient and awfully cute.
-
Had baked beans with dinner, and now having some more. I guess it's dessert.
