Yes, I really should have tried to learn more Blender, any Blender actually.

[grim_elsewhere@lgbtqia.space]

@afreytes Another option is to define the shape you want with flat faces, and use cylinders and the Boolean Modifier to essentially subtract the space of the cylinder from your wedge shape using Difference.

https://docs.blender.org/manual/en/latest/modeling/modifiers/generate/booleans.html

[joshuaacnewman@xeno.glyphpress.com]

@afreytes
If you’re trying to just get a shape like this to 3D print, TinkerCAD can take you surprisingly far.

After that, probably Plasticity.

Blender is terrible at CAD. People keep trying to adapt it, but then they give up.

[aegir@toot.wales]

@afreytes Is it taking that red cross section and extruding it around a cylinder or corner? I’ve done similar in blender using the bevel object under curve geometry: https://docs.blender.org/manual/en/2.80/modeling/curves/properties/geometry.html

[eobet@oldbytes.space]

@JoshuaACNewman @afreytes I agree with the above, but if you want to stick to Blender for some reason, I might have misunderstood but I think you might want just a bevel modifier with edge weights, or a revolve using geometry nodes (you can look up tutorials using either of those keywords).

[afreytes@mastodon.gamedev.place]

I heeded the advice from @JoshuaACNewman and @eobet to try TinkerCAD.

Except I used FreeCAD, from the Linux Mint Software Manager instead.

I have never used CAD software but somehow FreeCAD wasn't too hard to use. Though making the wedge took me a few tries and is still not perfect.

FreeCAD has "Sketch", where I just did the lines and the arc in 2D. Then I used the "Revolve" function to make it extrude into the quarter wedge.

Equidistant points make for easy scaling to fit.

[joshuaacnewman@xeno.glyphpress.com]

@afreytes @eobet
Awesome! I keep basically restarting learning FreeCAD. It has the typical FOSS hostility to new users, but I keep going at it anyway.

[afreytes@mastodon.gamedev.place]

The only downside to this was that Godot Engine seemingly cannot parse a FreeCAD GLTF export. But GLB and OBJ exports both worked.

[eobet@oldbytes.space]

@JoshuaACNewman @afreytes is you want a slightly more polished variant, there's AstoCAD. Although you currently need to pay for a subscription to use it. Also, there's something called Plasticity which is a bit interesting (but again not free, but a very good price for what you get).

[joshuaacnewman@xeno.glyphpress.com]

@eobet @afreytes
Plasticity is really, really cool. I’ve paid for two versions so far. I’m most encouraged by being able to save files so you can open them in FreeCAD later. I’m really, really sick of corporations holding my artwork and friends hostage.

[joshuaacnewman@xeno.glyphpress.com]

@eobet @afreytes
Last I checked on AstoCAD, it was basically a set of promises. I’ll check again!