#NetBSD people.. HP #PA-RISC 715/100XCHas anyone installed it recently?
Uncategorized
3
Posts
1
Posters
0
Views
-
Well downloaded iso, open install notes, ISO install not supported..
So lets go netboot -
Well downloaded iso, open install notes, ISO install not supported..
So lets go netbootI am booting something.. #Netbsd docs are interesting
๐ซฃ -
undefined stefano@mastodon.bsd.cafe shared this topic on
Gli ultimi otto messaggi ricevuti dalla Federazione
-
@aeva Ah you took that course too
-
@ObsidianUrbex ohmygod is that beautiful
-
@ObsidianUrbex there is some Guinness related house in Dublin people do this in
-
Current* conditions near Chicago, IL:
-
Conosci il significato della parola Nemesi?
https://www.youtube.com/watch?v=SBBCOusiVIA
-
Recycled Plastic Compression Molding With 3D-Printed Molds
Recycling plastic at home using 3D printed molds is relatively accessible these days, but if you do not wish to invest a lot of money into specialized equipment, whatโs the most minimal setup that you can get away with? In a recent [future things] video DIY plastic recycling is explored using only equipment that the average home is likely to have around.
Lest anyone complain, you should always wear PPE such as gloves and a suitable respirator whenever youโre dealing with hot plastic in this manner, just to avoid a trip to the emergency room. Once taken care of that issue, there are a few ways of doing molding, with compression molding being one of the most straightforward types.
With compression molding you got two halves of a mold, of which one compresses the material inside the other half. This means that you do not require any complex devices like with injection molding, just a toaster oven or equivalent to melt the plastic, which is LDPE in this example. The scrap plastic is placed in a silicone cup before itโs heated so that it doesnโt stick to the container.
The wad of goopy plastic is then put inside the bottom part of the mold before the top part is put in place and squeezed by hand until molten plastic comes out of the overflow opening(s). After letting it fully cool down, the mold is opened and the part released. Although the demonstrated process can be improved upon, it seems to work well enough if you are aware of the limitations. In terms of costs and parts required itโs definitely hard to come up with a cheaper way to do plastic molding.
-
Banksy rivelato dai giornalisti: la ricerca รจ o puรฒ essere eliminata? http://www.taz.de/Banksy-durch-Journalisten-enthuellt/!6163029/
-
Current* conditions near Goulais River, ON:
