Tried to make a stamp today with my 3D printer using PLA for the handle and TPU for the stamp.
-
Tried to make a stamp today with my 3D printer using PLA for the handle and TPU for the stamp. Results are meh. Maybe the flow rates aren’t right which leaves the gaps. I did use the iron feature on the top layer too.
-
Tried to make a stamp today with my 3D printer using PLA for the handle and TPU for the stamp. Results are meh. Maybe the flow rates aren’t right which leaves the gaps. I did use the iron feature on the top layer too.
That’s somewhat better. 100% infill (was 20%) and top iron at 20% flow (was 10%). Also using the TPU (85A) manufacturer settings file for Bambu P1S.
-
That’s somewhat better. 100% infill (was 20%) and top iron at 20% flow (was 10%). Also using the TPU (85A) manufacturer settings file for Bambu P1S.
LaserWriter 8 Page Setup
-
LaserWriter 8 Page Setup
Stamps, stamps, stamps!
-
undefined oblomov@sociale.network shared this topic on
-
Stamps, stamps, stamps!
@paulrickards you cracked the secret formula! Now tell us the details. TPU settings?
Feed RSS
Gli ultimi otto messaggi ricevuti dalla Federazione
Post suggeriti
-
-
-
27 settembre 1983#accaddeoggiRichard Matthew Stallman, informatico e attivista USA, annuncia il progetto GNU con lo slogan "Gnu is Not Unix".
Uncategorized
1
-
𝗖𝗢𝗠𝗠𝗢𝗗𝗢𝗥𝗘 𝟲𝟰 𝗨𝗟𝗧𝗥𝗔 𝗖𝗢𝗡𝗩𝗜𝗡𝗖𝗘: 𝗕𝗢𝗢𝗠 𝗗𝗜 𝗩𝗘𝗡𝗗𝗜𝗧𝗘 𝗘 𝗔𝗖𝗤𝗨𝗜𝗦𝗜𝗭𝗜𝗢𝗡𝗘 𝗔𝗡𝗧𝗜𝗖𝗜𝗣𝗔𝗧𝗔 𝗗𝗘𝗜 𝗠𝗔𝗥𝗖𝗛𝗜Appassionati e collezionisti confermano il forte legame emotivo col celebre home computer degli anni '80
Uncategorized
1
