Tried to make a stamp today with my 3D printer using PLA for the handle and TPU for the stamp.
-
Tried to make a stamp today with my 3D printer using PLA for the handle and TPU for the stamp. Results are meh. Maybe the flow rates aren’t right which leaves the gaps. I did use the iron feature on the top layer too.
-
Tried to make a stamp today with my 3D printer using PLA for the handle and TPU for the stamp. Results are meh. Maybe the flow rates aren’t right which leaves the gaps. I did use the iron feature on the top layer too.
That’s somewhat better. 100% infill (was 20%) and top iron at 20% flow (was 10%). Also using the TPU (85A) manufacturer settings file for Bambu P1S.
-
That’s somewhat better. 100% infill (was 20%) and top iron at 20% flow (was 10%). Also using the TPU (85A) manufacturer settings file for Bambu P1S.
LaserWriter 8 Page Setup
-
LaserWriter 8 Page Setup
Stamps, stamps, stamps!
-
undefined Oblomov ha condiviso questa discussione
-
Stamps, stamps, stamps!
@paulrickards you cracked the secret formula! Now tell us the details. TPU settings?
Feed RSS
Gli ultimi otto messaggi ricevuti dalla Federazione
Post suggeriti
-
29 settembre 1983#accaddeoggiLancio di Microsoft Word, sviluppato da Charles Simonyl e Richard Brodie, ex Xerox, assunti da Gates e Allen nel 1981.
Senza categoria1
-
A NoteCards "browser" is a type of card that shows a hypertext network as a graph structure, i.e. a graph view like in this example.
Senza categoria1
-
-