I use FreeCAD a lot to create drill templates for all sorts of things.
Uncategorized
1
Posts
1
Posters
0
Views
-
I use FreeCAD a lot to create drill templates for all sorts of things. This time i created a mounting plate for my Makita Jigsaw. This way i can mount it to a sheet of plywood quickly and use it in an upside down style config. Like a poor mans table saw.
-
undefined oblomov@sociale.network shared this topic on
Gli ultimi otto messaggi ricevuti dalla Federazione
-
-
-
Many articles I read from before 2024 contain correct but dated information. Many articles I read from after 2024 contain incorrect information, obvious LLM hallucinations.
The internet is becoming an increasingly difficult 'place' to manage.
-
la cosa più deleteria che ha fatto threads sul fediverso, in europa, sono state le discussioni inutili.
Che tanto, campa cavallo
-
-
@randulo ROTFL
-
@handmade_ghost «I can't see anything»
«Keep looking, I'm sure I dropped somewhere around here.»
-
@migbox
Penso di sì ma non è quello il punto.
Post suggeriti
-
-
Très content de ma boîte japonaise faire à partir d'un chevron en chêne récupéré le bois doit avoir au moins 200 ans.
Uncategorized
4
-
As I wanted to mount a zigbee indoor sensor outside (as a trial), I spent the past evenings designing and printing a gill shield.
Uncategorized
2
-
In order to 3d print a little amplified speaker box to use for #HamRadio SSB 2-operator POTA with my wife, I want to model components and then model the box to go around them.
Uncategorized
3
