I've got a weird issue on my #FreeBSD ThinkPad. Since setting up lagg yesterday which worked fine. I powered off last night and then switched it on this morning. I noticed that I had no network access on either the re1 interface or wlan0. I powered off and on and it worked. I have since discovered that if it doesn't work if I just doas service netif restart it starts to work again.This is my lagg setup in /etc/rc.conf# WiFiwlans_iwlwifi0="wlan0"ifconfig_wlan0="WPA SYNCDHCP"cloned_interfaces="lagg0"ifconfig_lagg0="up laggproto failover laggport re1 laggport wlan0 DHCP"This is the output of ifconfig when it's working:re0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500 options=8209b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,WOL_MAGIC,LINKSTATE> ether 8c:8c:aa:bd:bb:f0 media: Ethernet autoselect (none) status: no carrier nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>re1: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500 options=80088<VLAN_MTU,VLAN_HWCSUM,LINKSTATE> ether 8c:8c:aa:bd:bb:ef inet 192.168.0.194 netmask 0xffffff00 broadcast 192.168.0.255 media: Ethernet autoselect (1000baseT <full-duplex>) status: active nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>lo0: flags=1008049<UP,LOOPBACK,RUNNING,MULTICAST,LOWER_UP> metric 0 mtu 16384 options=680003<RXCSUM,TXCSUM,LINKSTATE,RXCSUM_IPV6,TXCSUM_IPV6> inet 127.0.0.1 netmask 0xff000000 inet6 ::1 prefixlen 128 inet6 fe80::1%lo0 prefixlen 64 scopeid 0x3 groups: lo nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>wlan0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500 options=0 ether 8c:8c:aa:bd:bb:ef hwaddr 70:9c:d1:af:ad:93 inet 192.168.0.194 netmask 0xffffff00 broadcast 192.168.0.255 groups: wlan ssid Smithies channel 40 (5200 MHz 11a vht/80-) bssid f0:9f:c2:ab:8d:c3 regdomain FCC country US authmode WPA2/802.11i privacy ON deftxkey UNDEF AES-CCM 2:128-bit AES-CCM ucast:128-bit txpower 17 bmiss 7 mcastrate 6 mgmtrate 6 scanvalid 60 ampdulimit 64k ampdudensity 8 -amsdutx amsdurx shortgi -ldpctx ldpcrx -uapsd vht vht40 vht80 vht160 -vht80p80 wme roaming MANUAL parent interface: iwlwifi0 media: IEEE 802.11 Wireless Ethernet VHT mode 11ac status: associated nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>lagg0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500 options=0 ether 8c:8c:aa:bd:bb:ef hwaddr 00:00:00:00:00:00 inet 192.168.0.194 netmask 0xffffff00 broadcast 192.168.0.255 laggproto failover lagghash l2,l3,l4 laggport: re1 flags=5<MASTER,ACTIVE> laggport: wlan0 flags=0<> groups: lagg media: Ethernet autoselect status: active nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>This is the output when not working on first boot:re0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500 options=8209b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,WOL_MAGIC,LINKSTATE> ether 8c:8c:aa:bd:bb:f0 media: Ethernet autoselect (none) status: no carrier nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>re1: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500 options=80088<VLAN_MTU,VLAN_HWCSUM,LINKSTATE> ether 8c:8c:aa:bd:bb:ef inet 192.168.0.194 netmask 0xffffff00 broadcast 192.168.0.255 media: Ethernet autoselect (1000baseT <full-duplex>) status: active nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>lo0: flags=1008049<UP,LOOPBACK,RUNNING,MULTICAST,LOWER_UP> metric 0 mtu 16384 options=680003<RXCSUM,TXCSUM,LINKSTATE,RXCSUM_IPV6,TXCSUM_IPV6> inet 127.0.0.1 netmask 0xff000000 inet6 ::1 prefixlen 128 inet6 fe80::1%lo0 prefixlen 64 scopeid 0x3 groups: lo nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>wlan0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500 options=0 ether 8c:8c:aa:bd:bb:ef hwaddr 70:9c:d1:af:ad:93 inet 192.168.0.194 netmask 0xffffff00 broadcast 192.168.0.255 groups: wlan ssid Smithies channel 40 (5200 MHz 11a vht/80-) bssid f0:9f:c2:ab:8d:c3 regdomain FCC country US authmode WPA2/802.11i privacy ON deftxkey UNDEF AES-CCM 2:128-bit AES-CCM ucast:128-bit txpower 17 bmiss 7 mcastrate 6 mgmtrate 6 scanvalid 60 ampdulimit 64k ampdudensity 8 -amsdutx amsdurx shortgi -ldpctx ldpcrx -uapsd vht vht40 vht80 vht160 -vht80p80 wme roaming MANUAL parent interface: iwlwifi0 media: IEEE 802.11 Wireless Ethernet VHT mode 11ac status: associated nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>lagg0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500 options=0 ether 8c:8c:aa:bd:bb:ef hwaddr 00:00:00:00:00:00 inet 192.168.0.194 netmask 0xffffff00 broadcast 192.168.0.255 laggproto failover lagghash l2,l3,l4 laggport: re1 flags=5<MASTER,ACTIVE> laggport: wlan0 flags=0<> groups: lagg media: Ethernet autoselect status: active nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>I should note that running doas service netif restart once it's working makes it fail again.Any ideas ??
💨
