Buongiorno gente di queste parti.
Uncategorized
1
Posts
1
Posters
2
Views
-
RE: https://bologna.one/@victorvandort/115939396425019079
Buongiorno gente di queste parti. Dato che qua non vogliamo annoiarci vi segnalo abbiamo aggiunto anche Nextcloud alla piattaforma. I test proseguono, ma nuovi tester sono sempre ben accetti
Gli ultimi otto messaggi ricevuti dalla Federazione
-
-
@simone
Qui è così... umida che pioviggina... 🤷
-
@Gina I wish I could have seen it in person, but I'm one of the poor sods waiting outside because you all woke up way too early to fill that room 😂
-
@Gina 👏🏼
-
On the tram to #FOSDEM. Looking forward to the devroom. Everyone's slides are all packed up!
-
Compie oggi 89 anni. E non molla un cazzo. #PhilipGlass e il rifiuto a Trump: non si esibirà al #KennedyCenter – La Voce di New York https://lavocedinewyork.com/news/2026/01/27/philip-glass-e-il-rifiuto-a-trump-non-si-esibira-al-kennedy-center/
-
Cats are not from this world 😍
-
I've got a weird issue on my #FreeBSD ThinkPad. Since setting up lagg yesterday which worked fine. I powered off last night and then switched it on this morning. I noticed that I had no network access on either the re1 interface or wlan0. I powered off and on and it worked. I have since discovered that if it doesn't work if I just doas service netif restart it starts to work again.
This is my lagg setup in /etc/rc.conf
# WiFi
wlans_iwlwifi0="wlan0"
ifconfig_wlan0="WPA SYNCDHCP"
cloned_interfaces="lagg0"
ifconfig_lagg0="up laggproto failover laggport re1 laggport wlan0 DHCP"
This is the output of ifconfig when it's working:
re0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=8209b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,WOL_MAGIC,LINKSTATE>
ether 8c:8c:aa:bd:bb:f0
media: Ethernet autoselect (none)
status: no carrier
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
re1: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500
options=80088<VLAN_MTU,VLAN_HWCSUM,LINKSTATE>
ether 8c:8c:aa:bd:bb:ef
inet 192.168.0.194 netmask 0xffffff00 broadcast 192.168.0.255
media: Ethernet autoselect (1000baseT <full-duplex>)
status: active
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
lo0: flags=1008049<UP,LOOPBACK,RUNNING,MULTICAST,LOWER_UP> metric 0 mtu 16384
options=680003<RXCSUM,TXCSUM,LINKSTATE,RXCSUM_IPV6,TXCSUM_IPV6>
inet 127.0.0.1 netmask 0xff000000
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x3
groups: lo
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
wlan0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500
options=0
ether 8c:8c:aa:bd:bb:ef
hwaddr 70:9c:d1:af:ad:93
inet 192.168.0.194 netmask 0xffffff00 broadcast 192.168.0.255
groups: wlan
ssid Smithies channel 40 (5200 MHz 11a vht/80-) bssid f0:9f:c2:ab:8d:c3
regdomain FCC country US authmode WPA2/802.11i privacy ON
deftxkey UNDEF AES-CCM 2:128-bit AES-CCM ucast:128-bit txpower 17
bmiss 7 mcastrate 6 mgmtrate 6 scanvalid 60 ampdulimit 64k
ampdudensity 8 -amsdutx amsdurx shortgi -ldpctx ldpcrx -uapsd vht
vht40 vht80 vht160 -vht80p80 wme roaming MANUAL
parent interface: iwlwifi0
media: IEEE 802.11 Wireless Ethernet VHT mode 11ac
status: associated
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
lagg0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500
options=0
ether 8c:8c:aa:bd:bb:ef
hwaddr 00:00:00:00:00:00
inet 192.168.0.194 netmask 0xffffff00 broadcast 192.168.0.255
laggproto failover lagghash l2,l3,l4
laggport: re1 flags=5<MASTER,ACTIVE>
laggport: wlan0 flags=0<>
groups: lagg
media: Ethernet autoselect
status: active
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
This is the output when not working on first boot:
re0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=8209b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,WOL_MAGIC,LINKSTATE>
ether 8c:8c:aa:bd:bb:f0
media: Ethernet autoselect (none)
status: no carrier
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
re1: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500
options=80088<VLAN_MTU,VLAN_HWCSUM,LINKSTATE>
ether 8c:8c:aa:bd:bb:ef
inet 192.168.0.194 netmask 0xffffff00 broadcast 192.168.0.255
media: Ethernet autoselect (1000baseT <full-duplex>)
status: active
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
lo0: flags=1008049<UP,LOOPBACK,RUNNING,MULTICAST,LOWER_UP> metric 0 mtu 16384
options=680003<RXCSUM,TXCSUM,LINKSTATE,RXCSUM_IPV6,TXCSUM_IPV6>
inet 127.0.0.1 netmask 0xff000000
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x3
groups: lo
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
wlan0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500
options=0
ether 8c:8c:aa:bd:bb:ef
hwaddr 70:9c:d1:af:ad:93
inet 192.168.0.194 netmask 0xffffff00 broadcast 192.168.0.255
groups: wlan
ssid Smithies channel 40 (5200 MHz 11a vht/80-) bssid f0:9f:c2:ab:8d:c3
regdomain FCC country US authmode WPA2/802.11i privacy ON
deftxkey UNDEF AES-CCM 2:128-bit AES-CCM ucast:128-bit txpower 17
bmiss 7 mcastrate 6 mgmtrate 6 scanvalid 60 ampdulimit 64k
ampdudensity 8 -amsdutx amsdurx shortgi -ldpctx ldpcrx -uapsd vht
vht40 vht80 vht160 -vht80p80 wme roaming MANUAL
parent interface: iwlwifi0
media: IEEE 802.11 Wireless Ethernet VHT mode 11ac
status: associated
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
lagg0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500
options=0
ether 8c:8c:aa:bd:bb:ef
hwaddr 00:00:00:00:00:00
inet 192.168.0.194 netmask 0xffffff00 broadcast 192.168.0.255
laggproto failover lagghash l2,l3,l4
laggport: re1 flags=5<MASTER,ACTIVE>
laggport: wlan0 flags=0<>
groups: lagg
media: Ethernet autoselect
status: active
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
I should note that running doas service netif restart once it's working makes it fail again.
Any ideas ??
